Netapp vfiler dns setup

You can use any of these options with the setup command: The -e option creates the bindings of the vFiler unit and provides netmask with IPv4 address and prefixlen with IPv6 address. The -e option creates the bindings of the vFiler unit 's IP addresses. The -a option specifies the administrator host name and IP address. The -p option sets the password of the vFiler unit 's root user.

Otherwise, setup is complete. After you respond to all the prompts, CIFS starts running. One option would be to pre-create the user and then re-test. Also which version of WFA are you running? This was last tested on 1. Yes, I'm using a user called wfauser on the physical filer. On the vfiler no user exists.

I'm using WFA 1. I have the impression that this is not sufficient. Am I right? I have a feeling that this is your issue. I ran into some odd issue in the past pre 1. Can you try with root and see if it is any different? It took some time but now I could test the New-NaUser cmdlet on the vfiler.

You are right. It only works with the root user. Determine whether to modify the caching policy of Flash Pool aggregates. Use FlexClone volumes to create efficient copies of your FlexVol volumes. Difference in space usage displayed by a quota report and a UNIX client. Use deduplication, data compression, and data compaction to increase storage efficiency. Balance network loads to optimize user traffic cluster administrators only. Verify that the configuration is capable of nondisruptive operations.

Display information about audit policies applied to files and directories. Use security tracing to verify or troubleshoot file and directory access.

Configure DNS services.