Each GPO is restored using its most recent backup. If the domain of user that is running the session or, for a startup or shutdown script, the domain of the computer is different from the contoso.
Indicates that the cmdlet restores all GPOs in the domain that have backups in the backup directory. Each GPO is restored from its most recent backup in the directory. You can use this parameter to specify a particular version of a backed-up GPO in the backup directory.
Specifies the domain for this cmdlet. You must specify the fully qualified domain name FQDN of the domain. This must be the domain from which the GPO was backed up.
If you do not specify the Domain parameter, the domain of the user that is running the current session is used. If the cmdlet is being run from a computer startup or shutdown script, the domain of the computer is used. For more information, see the Notes section in the full Help. If you specify a domain that is different from the domain of the user that is running the current session or, for a startup or shutdown script, the computer , a trust must exist between that domain and the domain of the user or the computer.
You can also refer to the Domain parameter by its built-in alias, domainname. The GPO is restored from its most recent backup in the backup directory. To specify a different backup than the most recent backup, use the BackupId parameter.
Specifies the GPO to restore by its display name. The display name is not guaranteed to be unique in the domain. If another GPO with the same display name exists in the domain an error occurs. Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully.
For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:. Was this reply helpful?
Yes No. Sorry this didn't help. Thanks for your feedback. Hi, I got a hard time figuring out when did I change this setting in 'System Protection'. In the 'Automatic Restore Point - Restore point creation disabled by group policy'. This had been greyout. Hello Everyone! Thanks for your time! Wednesday, October 20, PM. This posting is provided "AS IS" with no warranties, and confers no rights. Please remember to click "Mark as Answer" on the post that helps you, and to click "Unmark as Answer" if a marked post does not actually answer your question.
This can be beneficial to other community members reading the thread. Thursday, October 21, AM. Hi, The same behavior occurs on my system. Thursday, October 28, AM. Please check the information on the two links and see if it helps, Gunter. Thanks for the well written instructions, Mervyn!
Any ideas? Thanks so much for your time and energy! Friday, October 22, PM. Hi, Could you run the task manually? Please also try to reboot the system and test again. Monday, October 25, AM. Hi, Do you need any other assistance? If there is anything we can do for you, please let us know. Wednesday, October 27, AM. Thanks for your persistence, Mervyn! Wednesday, October 27, PM. Thanks for the explanation! Mervyn, you've been great! Thank you! Friday, October 29, PM. Monday, November 1, AM.
Or do I need to modify the script to run on my workstation? Saturday, June 18, PM. Just discovered something interesting--on a hunch, I just turned off System Protection on my data D: drive and manually ran the default SystemRestore task. And what do you know--I got an automatic system restore point! Note that I had to manually stop the task--it was still running after 3 minutes it takes only about 1 minute to create a restore point.
0コメント